Hirschmann RS20 - Spanning-Tree Hold-Count

CLI Commands: Switching
CLI L2P
Release 7.0 05/2011
5.1 Spanning Tree Commands
419
5.1.21 spanning-tree hold-count
This command sets the bridge hold count parameter.
Default
disabled
Format
spanning-tree hold-count <1-40>
Mode
Global Config
<1-40>
Enter the bridge parameter for hold count as an integer in the range
1 - 40.
U no spanning-tree hold-count
This command sets bridge hold count to disabled.
Format
no spanning-tree hold-count
Mode
Global Config