248
4.9
Device Configuration Commands
CLI L2P
Release
7.0
05/2011
4.9.92 storm-control flowcontrol per port
This command enables 802.3x flow control for the port.
Note: This command only applies to full-duplex mode ports.
Default
enabled
Format
storm-control flowcontrol
Mode
Interface Config
U no storm-control flowcontrol per port
This command disables 802.3x flow control for the port.
Note: This command only applies to full-duplex mode ports.
Format
no storm-control flowcontrol
Mode
Interface Config
To Next Page
Loading...
