CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.1
System Information and Statistics Com-
69
4.1.19 show mac-addr-table
This command displays the forwarding database entries. If the command is
entered with no parameter, the entire table is displayed. This is the same as
entering the optional all parameter. Alternatively, the administrator can en-
ter a MAC Address to display the table entry for the requested MAC address
and all entries following the requested MAC address.
Note: This command displays only learned unicast addresses. For other
addresses use the command show mac-filter-table.
See “show mac-filter-table gmrp” on page 219.
Format
show mac-addr-table [<macaddr> <1-4042> | all]
Mode
Privileged EXEC and User EXEC
Mac Address
A unicast MAC address for which the switch has forwarding and or filtering
information. The format is 6 or 8 two-digit hexadecimal numbers that are
separated by colons, for example 01:23:45:67:89:AB.
Slot/Port
The port which this address was learned.
if Index
This object indicates the ifIndex of the interface table entry associated
with this port.
Status
The status of this entry. The meanings of the values are:
Learned The value of the corresponding instance was learned by
observing the source MAC addresses of incoming traffic, and is cur-
rently in use.
Management The value of the corresponding instance (system MAC
address) is also the value of an existing instance of
dot1dStaticAddress.
To Next Page
Loading...
Need help?
General
