EasyManuals Logo

Hirschmann RS20 Reference Manual

Hirschmann RS20
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #274 background imageLoading...
Page #274 background image
274
4.10
User Account Management Commands
CLI L2P
Release
7.0
05/2011
4.10.8 users passwd
This command is used to change a password. The password should not be
more than eight alphanumeric characters in length. If a user is authorized for
authentication or encryption is enabled, the password must be at least eight
alphanumeric characters in length. The username and password are case-
sensitive. When a password is changed, a prompt will ask for the former
password. If none, press enter.
Note: Make sure, that the passwords of the users differ from each other. If
two or more users try to choose the same password, the CLI will display an
error message.
Default
No Password
Format
users passwd <username> {<password>}
Mode
Global Config
U no users passwd
This command sets the password of an existing operator to blank. When
a password is changed, a prompt will ask for the operator's former pass-
word. If none, press enter.
Format
no users passwd <username> {<password>}
Mode
Global Config

Table of Contents

Other manuals for Hirschmann RS20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hirschmann RS20 and is the answer not in the manual?

Hirschmann RS20 Specifications

General IconGeneral
MountingDIN Rail
Operating Temperature-40°C to +70°C
Protection ClassIP30
Switching TechnologyStore-and-Forward
Product TypeIndustrial Ethernet Switch
Port Details10/100 Mbps Ethernet ports
Switching Capacity3.2 Gbps
MAC Address Table8k
ManagementWeb, SNMP
RedundancyMRP
Ports8 or 16

Related product manuals