Hirschmann RS20 Reference Manual

CLI L2P
Release 7.0 05/2011
4.9 Device Configuration Commands
231
4.9.71 show storm-control limiters port
This command displays the limiter settings per port. "0" means that the re-
spective limiter is disabled.
Format
show storm-control limiters port {<slot/port>|all}
Mode
Privileged EXEC and User EXEC
Ingress Mode (RS20/RS30/RS40, MS20/MS30 and OCTOPUS only)
Shows the mode for the ingress limiter. The factory default is: Broad-
casts only.
Ingress Limit
Shows the ingress rate limit. The factory default is: 0.
Egress Broadcast Limit
Shows the egress broadcast rate limit. The factory default is: 0.
Egress Limit (all traffic; RS20/RS30/RS40, MS20/MS30 and OCTOPUS
only)
Shows the egress rate limit for all frame types.
The factory default is: 0.
4.9.72 show vlan
This command displays detailed information, including interface information,
for a specific VLAN. The ID is a valid VLAN identification number
Format
show vlan <vlanid>
Mode
Privileged EXEC and User EXEC
VLAN ID
There is a VLAN Identifier (VID) associated with each VLAN. The
range of the VLAN ID is 1 to 4042.

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16