310
4.12
LLDP - Link Layer Discovery Protocol
CLI L2P
Release
7.0
05/2011
4.12.11show lldp config port tlv
This command shows all LLDP TLV configuration settings (if the given infor-
mation is included in the sent LLDP frames or not) concerning one or all
ports.
Format
show lldp config port <{slot/port|all}> tlv
Mode
Privileged EXEC and User EXEC
inlinepower
Enable or disable the sending of the port's Power over Ethernet capa-
bilities (PoE, IEEE 802.3af), available for devices supporting PoE.
link-aggregation
Display the port's LLDP TLV inclusion of Link Aggregation.
mac-phy-config-state
Display the port's LLDP TLV inclusion of MAC Phy. Cfg. State.
max-frame-size
Display the port's LLDP TLV inclusion of Max. Frame Size.
PROFINET IO Status
Display the port's LLDP TLV inclusion of PROFINET IO Status.
PROFINET IO Alias
Display the port's LLDP TLV inclusion of PROFINET IO Alias.
PROFINET IO MRP
Display the port's LLDP TLV inclusion of PROFINET IO MRP.
mgmt-addr
Display the port's LLDP TLV inclusion of Management Address.
port-desc
Display the port's LLDP TLV inclusion of Port Description.
port-vlan
Display the port's LLDP TLV inclusion of Port VLAN.
protocol
Display the port's LLDP TLV inclusion of Protocol.