CLI Commands: Security
498
6.1
Security Commands
CLI L2P
Release
7.0
05/2011
6.1.7 dot1x guest-vlan
This command configures VLAN as guest vlan on an interface. The
command specifies an active VLAN as an IEEE 802.1x guest VLAN.
The range is 1 to the maximum VLAN ID supported by the platform.
Format
dot1x guest-vlan <vlan-id>
Mode
Interface Config
<vlan-id>
Enter an existing VLAN ID.
U no dot1x guest-vlan
This command is used to disable Guest VLAN for the port.
Format
no dot1x guest-vlan
Mode
Global Config
To Next Page
Loading...
