CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
127
Management VLAN IP-DSCP Value
Specifies the management VLAN IP-DSCP value.
Java Script Mode
Specifies if the Switch will use Java Script to start the Management
Applet. The factory default is enabled.
4.6.38 show network mgmt-access
This command displays the operating status and entries for restricted
management access (RMA).
Format
show network mgmt-access
Mode
Privileged EXEC and User EXEC
Operation
Indicates whether the opeartion for RMA is enabled or not.
The options are Enabled | Disabled.
ID
Index of the entry for restricted management access (1 to max. 16).
IP Address
The IP address which should have access to management.
The factory default value is 0.0.0.0.
Netmask
The network mask to allow a subnet for management access.
The factory default value is 0.0.0.0.
HTTP
Indicates whether HTTP is allowed to have management access or
not. The options are Yes | No.
SNMP
Indicates whether SNMP is allowed to have management access or
not. The options are Yes | No.
To Next Page
Loading...
