Hirschmann RS20 Reference Manual

CLI Commands: Base
136
4.6 Management Commands
CLI L2P
Release 7.0 05/2011
4.6.48 snmp-access version
This command configures the SNMP version specific access mode for
SNMPv1 and SNMPv2.
Format
snmp-access version {all|v1|v2} {disable|enable}
Mode
Global Config
all
Enable or disable SNMP access by all protocol versions (v1 and v2).
v1
Enable or disable SNMP access by v1.
v2
Enable or disable SNMP access by v2.
4.6.49 snmp-access version v3-encryption
Use this command to activate/deactivate SNMPv3 data encryption.
Format
snmp-access version v3-encryption
{readonly | readwrite} {enable | disable}
Mode
Global Config
disable
Disable SNMP access to this switch by SNMPv3 protocol version.
enable
Enable SNMP read and write access to this switch by SNMPv3
protocol version.
readonly
Enable SNMP read-only access to this switch (disable write access)
by SNMPv33 protocol version.

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16