CLI L2P
Release
7.0
05/2011
4.11
System Utilities
301
4.11.27reboot
This command resets the switch (cold start) after a given time delay, for warm
start See “reload” on page 302. Reset means that all network connections
are terminated and the boot code executes. The switch uses the stored con-
figuration to initialize the switch. You are prompted to confirm that the reset
should proceed. A successful reset is indicated by the LEDs on the switch.
Format
reboot {delay <seconds>}
Mode
Privileged EXEC
<seconds>
The number of seconds after which the switch will reboot.
Value range: None (no reboot sceduled), 0 - 2,147,483 sec (= 596 h +
31 min + 23 sec).
U clear reboot
This command cancels a scheduled reboot.
4.11.28show reboot
This command displays if a reboot is sceduled for the device. If sceduled, the
command displays the number of seconds after which the switch will reboot.
Format
show reboot
Modes
Privileged EXEC
User Exec
To Next Page
Loading...
