CLI Commands: Switching
476
5.8
DHCP Server Commands
CLI L2P
Release
7.0
05/2011
5.8.7 dhcp-server pool add <id>
Add a pool with a single IP address (static) or with an IP range (dynamic)
Format
dhcp-server pool {add <id> {static <ipaddr>
|dynamic <start ipaddr> <end ipaddr>}
Mode
Global Config
dhcp-server pool add <id> {static <ipaddr>}
Add a pool with a single IP address (static).
dhcp-server pool add <id> {dynamic <start ipaddr> <end ipaddr>}
Add a pool with an IP range (dynamic).
To Next Page
Loading...
