Hirschmann RS20

CLI L2P
Release 7.0 05/2011
4.11 System Utilities
279
4.11 System Utilities
This section describes system utilities.
4.11.1 address-conflict
This command configures the setting for detection possible address conflicts
of the agent´s IP address with other devices´ IP addresses in the network.
Format
address-conflict
{detection-mode { active-only | disable |
enable | passive-only}|
ongoing-detection { disable | enable } }
Mode
Global Config
detection mode
Configure the device's address conflict detection mode (active-only,
disable, enable or passive-only). Default: enable.
ongoing detection
Disable or enable the ongoing address conflict detection.
Default: enable.