Hirschmann RS20 Reference Manual

266
4.9 Device Configuration Commands
CLI L2P
Release 7.0 05/2011
4.9.111voice vlan untagged
Use this command to configure the phone to send untagged voice traffic.
Format
voice vlan untagged
Mode
Interface Config
4.9.112voice vlan auth
Use this command to set Voice VLAN Authentication Mode. If disabled, VOIP
devices which are detected via LLDP-med will have access to the Voice
VLAN without authentication.
Default
Enabled
Format
voice vlan auth [enabled | disabled]
Mode
Interface Config
disable
VOIP devices which are detected via LLDP-MED will have access to
the Voice VLAN without authentication.
enable
VOIP devices which are detected via LLDP-MED will not have access
to the Voice VLAN without authentication.

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16