CLI L2P
Release
7.0
05/2011
4.13
SNTP - Simple Network Time Protocol
337
address
Show the SNTP server's anycast destination IP Address.
transmit-interval
Show the SNTP Server's interval for sending Anycast messages
(unit: seconds).
vlan
Show the SNTP server's Anycast VLAN ID (used for sending Anycast
messages).
4.13.3 show sntp client
This command shows all SNTP anycast configuration settings.
Format
show sntp client [accept-broadcast|
disable-after-sync|
offset|
request-interval|
se
rver<p
rimary
|seco
ndary>|
threshold]
Mode
Privileged EXEC and User EXEC
accept-broadcast
Show if the SNTP Client accepts SNTP broadcasts.
disable-after-sync
Show if the SNTP client will be disabled once it is synchronized to the
time server.
offset
Show the local time's offset (in minutes) with respect to UTC (positive
values for locations east of Greenwich).
To Next Page
Loading...
