Quick Start up
34
2.1
Quick Starting the Switch
CLI L2P
Release
7.0
05/2011
2.1 Quick Starting the Switch
D Read the device Installation Guide for the connectivity procedure. In-band
connectivity allows access to the software locally or from a remote work-
station. The device must be configured with IP information (IP address,
subnet mask, and default gateway).
D Turn the Power on.
D Allow the device to load the software until the login prompt appears. The
device‘s initial state is called the default mode.
D When the prompt asks for operator login, execute the following steps:
D Type the word admin in the login area. Since a number of the Quick
Setup commands require administrator account rights, we recom-
mend logging into an administrator account. Press the enter key.
D Enter the state on delivery password private.
D Press the enter key
D The CLI User EXEC prompt will be displayed.
User EXEC prompt:
(Hirschmann Product) >
D Use “enable” to switch to the Privileged EXEC mode from User EXEC.
Privileged EXEC prompt:
(Hirschmann Product) #
D Use “configure” to switch to the Global Config mode from Privileged
EXEC.
Global Config prompt:
(Hirschmann Product) (Config)#
D Use “exit” to return to the previous mode.
To Next Page
Loading...
