CLI Commands: Base
148
4.6
Management Commands
CLI L2P
Release
7.0
05/2011
4.6.63 snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When en-
abled, link traps are sent only if the Link Trap flag setting associated with the
port is enabled (see ‘snmp trap link-status’ command).
Default
enabled
Format
snmp-server enable traps linkmode
Mode
Global Config
U no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
Format
no snmp-server enable traps linkmode
Mode
Global Config
To Next Page
Loading...
