Hirschmann RS20

CLI Commands: Base
122
4.6 Management Commands
CLI L2P
Release 7.0 05/2011
4.6.32 network priority
This command configures the VLAN priority or the IP DSCP value for out-
going management packets. The <ipdscp> is specified as either an integer
from 0-63, or symbolically through one of the following keywords:
af11,af12,af13,af21,af22,af23,af31,af32,af33,af41,af42,af43,be,cs0, cs1,
cs2,cs3,cs4,cs5,cs6,cs7,ef.
Default
0 for both values
Format
network priority {dot1p-vlan <0-7> |
ip-dscp <ipdscp> }
Mode
Privileged EXEC
U no network priority
This command sets the VLAN priority or the IP DSCP value for outgoing
management packets to default which means VLAN priority 0 or
IP DSCP value 0 (Best effort).
Format
no network priority {dot1p-vlan | ip-dscp }
Mode
Privileged EXEC