CLI Commands: Switching
412
5.1
Spanning Tree Commands
CLI L2P
Release
7.0
05/2011
5.1.14 spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and
internal spanning tree. This will allow this port to transition to Forwarding
State without delay.
Format
spanning-tree edgeport
Mode
Interface Config
U no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the com-
mon and internal spanning tree.
Format
no spanning-tree edgeport
Mode
Interface Config
To Next Page
Loading...
