Name: Hirschmann RS20
Brand: Hirschmann
Rating: 5 (1 reviews)

To Next Page

To Previous Page

280

4.11

System Utilities

CLI L2P

Release

7.0

05/2011

4.11.2 cablestatus

This command tests the cable attached to an interface for short or open

circuit. During the test the traffic is interrupted on this port.

Format

cablestatus <slot/port>

Mode

Privileged EXEC

4.11.3 clear eventlog

Clear the event log. The CLI will ask for confirmation.

Answer y (yes) or n (no).

The CLI displays the end of this operation.

Format

clear eventlog

Mode

Privileged EXEC

4.11.4 traceroute

This command is used to discover the routes that packets actually take when

traveling to their destination through the network on a hop-by-hop basis.

<ipaddr> should be a valid IP address.

The optional port parameter is the UDP port used as the destination of pack-

ets sent as part of the traceroute. This port should be an unused port on the

destination system. [port] should be a valid decimal integer in the range of 0

(zero) to 65,535. The default value is 33,434.

Other manuals for Hirschmann RS20

Questions and Answers:

Need help?

Do you have a question about the Hirschmann RS20 and is the answer not in the manual?

General