Hirschmann RS20 Reference Manual

CLI Commands: Base
96
4.6 Management Commands
CLI L2P
Release 7.0 05/2011
4.6.2 transport input telnet
This command regulates new telnet sessions. If sessions are enabled, new
telnet sessions can be established until there are no more sessions
available. If sessions are disabled, no new telnet sessions are established.
An established session remains active until the session is ended or an
abnormal network error ends the session.
Default
enabled
Format
transport input telnet
Mode
Line Config
U no transport input telnet
This command disables telnet sessions. If sessions are disabled, no new
telnet sessions are established.
Format
no transport input telnet
Mode
Line Config

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16