Hirschmann RS20 - Macfilter Adddest All

CLI L2P
Release 7.0 05/2011
4.9 Device Configuration Commands
179
4.9.11 macfilter adddest all
This command adds all interfaces to the destination filter set for the MAC filter
with the given <macaddr> and VLAN of <vlanid>. The <macaddr> parameter
must be specified as a 6-byte hexadecimal number in the format of
b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN (1 to 4042).
Format
macfilter adddest {all | <macaddr> <vlanid>}
Mode
Global Config
U no macfilter adddest all
This command removes all ports from the destination filter set for the
MAC filter with the given <macaddr> and VLAN of <vlanid>. The
<macaddr> parameter must be specified as a 6-byte hexadecimal num-
ber in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN (1 to 4042).
Format
no macfilter adddest [all | <macaddr> <vlanid>}
Mode
Global Config