Hirschmann RS20 Reference Manual

CLI Commands: Base
60
4.1 System Information and Statistics Com-
CLI L2P
Release 7.0 05/2011
4.1.16 show interface ethernet
This command displays detailed statistics for a specific port or for all CPU
traffic based upon the argument.
Format
show interface ethernet {<slot/port> | switchport}
Mode
Privileged EXEC and User EXEC
The display parameters, when the argument is '<slot/port>', are as follows :
Packets Received
Octets Received - The total number of octets of data (including those
in bad packets) received on the network (excluding framing bits but
including Frame Check Sequence (FCS) octets). This object can be
used as a reasonable estimate of ethernet utilization. If greater preci-
sion is desired, the etherStatsPkts and etherStatsOctets objects
should be sampled before and after a common interval. ----- The
result of this equation is the value Utilization which is the percent utili-
zation of the ethernet segment on a scale of 0 to 100 percent.
Packets Received < 64 Octets - The total number of packets (includ-
ing bad packets) received that were < 64 octets in length (excluding
framing bits but including FCS octets).
Packets Received 64 Octets - The total number of packets (includ-
ing bad packets) received that were 64 octets in length (excluding
framing bits but including FCS octets).
Packets Received 65-127 Octets - The total number of packets
(including bad packets) received that were between 65 and 127
octets in length inclusive (excluding framing bits but including FCS
octets).
Packets Received 128-255 Octets - The total number of packets
(including bad packets) received that were between 128 and 255
octets in length inclusive (excluding framing bits but including FCS
octets).
Packets Received 256-511 Octets - The total number of packets
(including bad packets) received that were between 256 and 511
octets in length inclusive (excluding framing bits but including FCS
octets).
Packets Received 512-1023 Octets - The total number of packets
(including bad packets) received that were between 512 and 1023

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16