194
4.9
Device Configuration Commands
CLI L2P
Release
7.0
05/2011
4.9.31 set garp timer leave
This command sets the GVRP leave time per port. Leave time is the time to
wait after receiving an unregister request for a VLAN or a multicast group be-
fore deleting the VLAN entry. This can be considered a buffer time for anoth-
er station to assert registration for the same attribute in order to maintain
uninterrupted service.time is 20 to 600 (centiseconds). The value 60 centi-
seconds is 0.6 seconds.
Note: This command has an effect only when GVRP is enabled.
Default
60
Format
set garp timer leave <20-600>
Mode
Global Config
Interface Config
U no set garp timer leave
TThis command sets the GVRP leave time per port to 60 centiseconds
(0.6 seconds).
Note: This command has an effect only when GVRP is enabled.
Format
no set garp timer leave
Mode
Global Config
Interface Config
To Next Page
Loading...
