Hirschmann RS20 Reference Manual

CLI L2P
Release 7.0 05/2011
4.9 Device Configuration Commands
193
4.9.30 set garp timer join
This command sets the GVRP join time per port and per GARP. Join time is
the interval between the transmission of GARP Protocol Data Units (PDUs)
registering (or re-registering) membership for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from
10 to 100 (centiseconds). The value 20 centiseconds is 0.2 seconds.
Default
20
Format
set garp timer join <10-100>
Mode
Global Config
Interface Config
U no set garp timer join
This command sets the GVRP join time per port and per GARP to 20
centiseconds (0.2 seconds). This command has an effect only when
GVRP is enabled.
Format
no set garp-timer join
Mode
Global Config
Interface Config

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16