Hirschmann RS20 Reference Manual

CLI L2P
Release 7.0 05/2011
4.9 Device Configuration Commands
213
4.9.54 selftest ramtest
Enable or disable the RAM test for a cold start of the device.
Deactivating the RAM test reduces the booting time for a cold start of the de-
vice.
Default: enabled.
Format
selftest ramtest {disable|enable}
Mode
Global Config
selftest ramtest disable
Disable the ramtest.
selftest ramtest enable
Enable the ramtest. This is the default.
4.9.55 selftest reboot-on-error
Enable or disable a restart due to an undefined software or hardware state.
Default: disabled.
Format
selftest reboot-on-error {disable|enable}
Mode
Global Config
selftest reboot-on-error disable
Disable the reboot-on-error function. This is the default.
selftest reboot-on-error enable
Enable the reboot-on-error function.

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16