Hirschmann RS20

CLI Commands: Security
CLI L2P
Release 7.0 05/2011
6.1 Security Commands
505
6.1.15 dot1x re-authenticate
This command begins the re-authentication sequence on the specified port.
This command is only valid if the control mode for the specified port is 'auto'.
If the control mode is not 'auto' an error will be returned.
Format
dot1x re-authenticate <slot/port>
Mode
Privileged EXEC
6.1.16 dot1x re-authentication
This command enables re-authentication of the supplicant for the specified
port.
Default
disabled
Format
dot1x re-authentication
Mode
Interface Config
U no dot1x re-authentication
This command disables re-authentication of the supplicant for the speci-
fied port.
Format
no dot1x re-authentication
Mode
Interface Config