CLI L2P
Release
7.0
05/2011
4.12
LLDP - Link Layer Discovery Protocol
309
4.12.10show lldp config port
This command shows all LLDP configuration settings and states concerning
one or all ports.
Format
show lldp config port <{slot/port|all}>
admin-state | fdb-mode | hm-mode |
max-neighbors | notification | tlv
Mode
Privileged EXEC and User EXEC
admin-state
Display the port's LLDP admin state (if LLDP/IEEE802.1AB frames
will be transmitted and/or received).
fdb-mode
Display the port's LLDP FDB mode.
hm-mode
Display the port's LLDP Hirschmann mode.
.max-neighbors
Display the port's max. no. of LLDP neighbors.
notification
Display the port's LLDP notification (trap) setting.
tlv
Display the port's LLDP TLV settings (they determine which informa-
tion is included in the LLDP frames that are sent). The command is a
group command and will output several lines of data.
To Next Page
Loading...
