CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.7
Syslog Commands
165
4.7.11 logging snmp-requests set severity
With this command you can define the severity level of logging SNMP SET
requests.
Default
Disabled
Format
logging snmp-requests set severity <level|[0-7]>
Mode
Global Config
level | [0-7]
Enter Logging Severity Level (emergency|0, alert|1, critical|2, error|3,
warning|4, notice|5, info|6, debug|7).
Note: selecting a lower severity level (larger number) will include all
messages from higher severity levels (smaller numbers).
To Next Page
Loading...
