CLI Commands: Security
CLI L2P
Release
7.0
05/2011
6.1
Security Commands
507
6.1.18 dot1x system-auth-control
This command is used to enable the dot1x authentication support on the
switch. By default, the authentication support is disabled. While disabled, the
dot1x configuration is retained and can be changed, but is not activated.
Default
disabled
Format
dot1x system-auth-control
Mode
Global Config
U no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the
switch.
Format
no dot1x system-auth-control
Mode
Global Config
To Next Page
Loading...
