Hirschmann RS20 Reference Manual

Mode-based CLI
44
3.2 Mode-based Command Hierarchy
CLI L2P
Release 7.0 05/2011
Interface Configuration mode, or the Protocol Specific modes speci-
fied below. The command prompt at this level is:
Command Prompt: (Hirschmann Product)(Config)#
From the Global Config mode, the operator may enter the following configu-
ration modes:
Interface Config Mode
Many features are enabled for a particular interface. The Interface
commands enable or modify the operation of an interface.
In this mode, a physical port is set up for a specific logical connection
operation. The Interface Config mode provides access to the router
interface configuration commands. The command prompt at this level
is:
Command Prompt: (Hirschmann Product)(Interface
<slot/port>)#
The resulting prompt for the interface configuration command entered
in the Global Configuration mode is shown below:
(Hirschmann Product)(Config)# interface 2/1
(Hirschmann Product)(Interface 2/1)#
Line Config Mode
This mode allows the operator to configure the console interface. The
operator may configure the interface from the directly connected con-
sole or the virtual terminal used with Telnet. The command prompt at
this level is:
Command Prompt: (Hirschmann Product)(Line)#
MAC Access-List Config Mode
Use the MAC Access-List Config mode to create a MAC Access-List
and to enter the mode containing Mac Access-List configuration com-
mands.
(Hirschmann Product)(Config)# mac-access-list
extended <name>
Command Prompt: (Hirschmann Product)(Config mac-
access-list)#

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16