Hirschmann RS20 Reference Manual

CLI Commands: Switching
CLI L2P
Release 7.0 05/2011
5.1 Spanning Tree Commands
423
(defined as the default CIST ID) is passed as the <mstid>, then the con-
figurations are performed for the common and internal spanning tree
instance.
This command accepts the value 0 for the mstid, meaning the common
and internal spanning tree.
If the ‘cost’ token is specified, this command sets the path cost for this
port within a multiple spanning tree instance or the common and internal
spanning tree instance, depending on the <mstid> parameter, to the
default value, i.e. a pathcost value based on the Link Speed.
If the ‘port-priority’ token is specified, this command sets the priority for
this port within a specific multiple spanning tree instance or the common
and internal spanning tree instance, depending on the <mstid> parame-
ter, to the default value, i.e. 128.
Format
no spanning-tree mst <mstid> <cost | port-priority>
Mode
Interface Config

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16