CLI L2P
Release
7.0
05/2011
4.11
System Utilities
293
Sy
stem
Name: <P
roduct
Name
>-5182
80
Mgmt-IP : a.b.c.d
1.Router-IP: 0.0.0.0
Base-MAC : aa:bb:cc:dd:ee:ff
System Time: 2010-01-02 05:51:11
---------------------------------------------------
The command uploads the CLI Banner file by tftp using
<tftp://ip/filepath/fileName>.
After the upload you logout from CLI and the new CLI banner file will
be displayed at the next login.
– url: Upload CLI banner file using <tftp://ip/filepath/fileName>.
If no cli banner file is defined, the default cli banner is displayed (see
above).
Note: See that the the CLI banner file you created has the following
properties:
- Use ASCII format (character codes 0x20 .. 0x7F, \n and \t
as C-like sequences)
- Do not use regular expressions
- Do not exeed the limit of 2048 byte
- Do not exceed the limit of 20 lines
- Do not exceed the limit of 80 characters per line
- A device can only have one banner file at the moment
- Save the CLI banner file as *.bnr.
U no clibanner
This command deletes an existing CLI banner file.
U copy <url> nvram:capturefilter <destfilename>
Load a Capture Filter file from a tftp URL into the flash memory using
<tftp://ip/filepath/fileName>.
– destfilename: Destination filename of capture filter expressions
file.
To Next Page
Loading...
Need help?
General
