Automation : Editing and Automation
15 - 379
Left Click
on an existing node to adjust it:
Ctrl + Click on an existing node to adjust all nodes in the Region selected currently:
Alt + Click anywhere on the Automation curve line to draw nodes freehand:
Ctrl + Alt + Click on an existing node to erase it:
Edit
Automation data can be edited directly with the mouse. When the mouse is over the of automation curve, the cur-
sor changes into an add node symbol. When the mouse is over a node of the automation curve, the value and
timestamp of the point is displayed.
The value can be adjusted by clicking on the node and dragging. If you click anywhere on the automation curve, a
new node will be inserted.
To Next Page
Loading...
