Menus : Edit
27 - 602
When this option is checked (enabled), then the Source material between the
Source Gate and the end of the Clip under the Gate instead of the whole Track is
copied to the Destination
3 Gates Auto-Edit does Overwrite
When this option is checked (enabled), then when 2 Gates are set in a Source and 1
is set in the Destination then AutoEdit performs an Overwrite operation.
3 Gates Auto-Edit does Insert
When this option is checked (enabled), then when 2 Gates are set in a Source and 1
is set in the Destination then AutoEdit performs an Insert operation
Automation Unchanged for Source Track Groups
Automation Off for Source Track Groups
Automation Play for Source Track Groups
Note:
For the above options: If the main Automation Mode is Write, then this mode is automatically changed to
Unchanged, Off or Play when a Source Track Group is selected, and changed back to Write when any other
Track Group is selected (typically the Destination one).
Note: When the following modes are enabled:
• Automation Off for Source Track Groups
• Automation Play for Source Track Groups
Then this also affects the
Enable Cut/Copy/Paste Automation mode (set to Off for Source Tracks).
Automation Editing
Enable Automation Editing
Enabled By Default. Enables Timeline Automation Editing. Mode is determined by
the next three entries:
Link to Media Content When enabled automation data is linked to the content so that if the Media Con-
tent is slipped the Automation data moves with it.
Cut/Copy/Delete Displayed Automation Will only affect Automation Curves visible in the Timeline when Editing
Cut/Copy/Delete Whole Strip Automation Enabled By Default. Will affect ALL Automation, even the curves not
visible currently in timeline Track(s) when editing.
Erase Points on Cut/Delete Erases all points contained within the selection. Does not add Automation points
to the selection boundaries.
Delete and Interpolate on Cut/Delete Enabled By Default. Interpolates a curve from the start of the selection to
end of the selection.
Delete and Maintain on Cut/Delete
Does not interpolate the curve from start to end of the selection. Therefore
maintains a flat curve on Cut or Delete.
Jog-Wheel Editing>
A number of editing actions may be undertaken on a selected Clip or group
of Clips using a jog-wheel on an external hardware controller.
First select the Clip or group of Clips, then select the desired Jog-Wheel Editing
Mode from the choice of:
Move
Move And XFade
Lock XFade Trim
Force XFade Trim Lock
Force XFade Trim Unlock
Trim In
Trim Out
To Next Page
Loading...
