Settings : Remote Control
28 - 706
•LTC
•VITC
•Control Track
The radio buttons select the source of the TimeCode from the external machine. Sony machines usually respond
to all requests, so the Auto setting will probably be appropriate. If necessary E.g. where there are several different
TimeCodes present on a tape, you can specify a desired TimeCode source to override the automatic setting. U-
Matic machines do not respond to all requests, therefore you must specify the TimeCode source.
Send In/Out Preset options
By default, Pyramix sends Edit Video In/Out and Edit Audio In/Out points when an In/Out point is set in the Trans-
port Control panel. These options enable these commands to filtered out if necessary.
• Filter In/Out Preset (video)
• Filter Audio In/Out Preset
Status Bit Filtering Options
Some SonyP2 devices do not report the Standby bit correctly (always in Standby). In this case the Pyramix Trans-
port Window reports Standby status continuously, thereby hiding the true status. You may wish to set filter if the
target machine fails to report standby correctly.
• Filter the Standby bit
Edit Preset channel options
Edit Preset in the 9-pin P2 protocol world means Track Arming.
These options enable Track Arming commands to be filtered out if required.
• Send Analog Edit Preset (A1..A2)
• Send Digital Edit Preset (D1..D8)
This feature is mostly relevant where a console or a third-party record/monitoring controller is used for record
commands.
Edit Preset Record Options
These 3 options Inhibit Recording when one of the Video/Timecode/Assemble Edit preset modes is checked and
the corresponding Track is armed. In a typical TV workflow, when audio is laid back to the tape, it is essential to
prevent the video track entering record (edit) These options avoid nasty accidents.
•Inhibit Video Record
•Inhibit TimeCode Record
• Inhibit Assemble Record
This feature is mostly relevant where a console or a third-party record/monitoring controller is used for record
commands.
To Next Page
Loading...
