Issue 4.0
2-10 Program 10 : System Configuration Setup
04
Layer 3 Timer Type
Each timer value of Layer 3
is set up for every type using
Program 81-06 (T-Bus).
1~5
1
05
CLIP Information Announcement
Based on this setting, the system
includes a Presentation Allowed (1) or
Presentation Restricted (0) in the Setup
message to allow or deny the Calling
Party Number. Program 15-01-04 must
also be set to 1 if this option is enabled.
0 = Disable
1 = Enable
1
06
Connection Bus Mode
0 = Extended Passive Bus
1 = Short Passive Bus
0
07
S-point DDI digits
0 ~ 4
0
08
Dial Sending Mode
ISDN Protocol definition
0 = Enblock Sending
1 = Overlap Sending
1
09
Dial Information Element
ISDN Protocol definition
[Only when Dialing Sending Mode
(10-03-08) is set for 1 (Overlap Sending]
0 = Keypad Facility
1 = Called Party Number
0
10
Master/Slave System
If set to 0, system is synchronized to the
network clock. If set to 1, system is not
synchronized to the network clock. (For
NW Mode)
0 = Slave System
1 = Master System
0
11
Networking System No. (for NW
Mode)
0~50
0
14
--- Not Used ---
15
--- Not Used ---
17
ISDN Line Ringback Tone
If Telco does not provide ringback tone,
SV9100 can if set to 1 (Enable).
0 = Disable
1 = Enable
0
18
Type of Number
ISDN Protocol definition
0 = Unknown
1 = International number
2 = National number
3 = Network specific number
4 = Subscriber number
5 = Abbreviated number
2
Item
No
Item Input Data Default
To Next Page
Loading...
