TP-Link JetStream T3700G-52TQ - Ip Dhcp Snooping Trust; Ip Dhcp Snooping Mac-Verify

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
13.8 ip dhcp snooping trust
Description
The ip dhcp snooping trust command is used to configure a port to be a
Trusted Port. Only the Trusted Port can receive the DHCP packets from
DHCP servers. To turn the port back to a distrusted port, please use no ip
dhcp snooping trust command.
Syntax
ip dhcp snooping trust
no ip dhcp snooping trust
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface ten-gigabitEthernet / interface range
ten-gigabitEthernet)
Example
Configure the Gigabit Ethernet port 1/0/2 to be a Trusted Port:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/2
T3700G-52TQ(config-if)#ip dhcp snooping trust
13.9 ip dhcp snooping mac-verify
Description
The ip dhcp snooping mac-verify command is used to enable the MAC
Verify feature. To disable the MAC Verify feature, please use no ip dhcp
snooping mac-verify command. There are two fields of the DHCP packet
containing the MAC address of the Host. The MAC Verify feature is to
compare the two fields and discard the packet if the two fields are different.
Syntax
ip dhcp snooping mac-verify
no ip dhcp snooping mac-verify
Command Mode
Global Configuration Mode
82