TP-Link JetStream T3700G-52TQ - Show Interface Configuration

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
show interface counters [ gigabitEthernet port | ten-gigabitEthernet port |
port-channel lagid ]
Parameter
port ——The port number or port list.
lagid —— The ID of LAG.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the statistic information of all Ethernet ports:
T3700G-52TQ(config)#show interface counters
Display the statistic information of Gigabit Ethernet port 20:
T3700G-52TQ(config)#show interface counters gigabitEthernet 1/0/20
23.16 show interface configuration
Description
The show interface configuration command is used to display the
configurations of an Ethernet port, including Port-status, Flow Control,
Negotiation Mode and Port-description.
Syntax
show interface configuration [ gigabitEthernet port | ten-gigabitEthernet
port | port-channel lagid ]
Parameter
port ——The port number or port list.
lagid —— The ID of LAG.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the configurations of Gigabit Ethernet port 20:
172