TP-Link JetStream T3700G-52TQ - Show Spanning-Tree Active; Show Spanning-Tree Bridge

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
spanning-tree mcheck
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet / interface
port-channel)
Example
Enable MCheck for Gigabit Ethernet port 1/0/2:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/2
T3700G-52TQ(config-if)#spanning-tree mcheck
30.22 show spanning-tree active
Description
The show spanning-tree active command is used to display the active
information of spanning-tree.
Syntax
show spanning-tree active
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the active information of spanning-tree:
T3700G-52TQ(config)#show spanning-tree active
30.23 show spanning-tree bridge
Description
The show spanning-tree bridge command is used to display the bridge
parameters.
Syntax
show spanning-tree bridge [forward-time | hello-time | hold-count | max-age
| max-hops | mode | priority | state]
246