TP-Link JetStream T3700G-52TQ - Show Mac Address-Table Count; Show Mac Address-Table Address

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
21.9 show mac address-table count
Description
The show mac address-table count command is used to display the total
amount of MAC address table.
Syntax
show mac address-table count [ unit unit-id ] [ vlan vlan-id ]
Parameter
unit--id —— Specify the unit-id of the switch in the stack.
vlan- id —— Specify the VLAN which the switch belongs to.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the total amount of MAC address table in all the units of the stack
sorted by VLAN:
T3700G-52TQ(config)#show mac address-table count
Display the total amount of MAC address table in unit 2 of the stack sorted by
VLAN:
T3700G-52TQ(config)#show mac address-table count unit 2
Display the total amount of MAC address table in VLAN 1 of unit 2 of the
stack:
T3700G-52TQ(config)#show mac address-table count unit 2 vlan 1
Display the total amount of MAC address table in VLAN 2 of all the units of the
stack:
T3700G-52TQ(config)#show mac address-table count vlan 2
21.10 show mac address-table address
Description
The show mac address-table address command is used to display the
information of a specified MAC address.
135