JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
time
—— The length of the quiet-period time. If one user’s authentication fails,
its subsequent IEEE 802.1x authentication requests will not be processed
during the quiet-period time. It ranges from 0 to 65535 seconds and the
default value is 60 seconds.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface ten-gigabitEthernet / interface range
ten-gigabitEthernet)
Example
Enable the quiet-period function and set the quiet-period as 5 seconds for
Gigabit Ethernet port 1/0/1:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/1
T3700G-52TQ(config-if)#dot1x timeout quiet-period 5
17.3 dot1x timeout supplicant-timeout
Description
The dot1x timeout supplicant-timeout command is used to configure the
supplicant timeout. To restore to the default, please use no dot1x timeout
supplicant-timeout command.
Syntax
dot1x timeout
supplicant-timeout
time
no dot1x timeout supplicant-timeout
Parameter
supplicant-timeout
time
——the maximum time to wait for
EAP-Response/MD5-challenge packet from the supplicant before timing out
the supplicant, ranging from 1 to 65535 in seconds. By default, it is 30
seconds.
97
To Next Page
Loading...
