TP-Link JetStream T3700G-52TQ - Show Classofservice Interface; Show Classofservice Cos-Map

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
bw —— The minimum bandwidth percentage for queue, ranging from 0 to
100 in increments of 1. By default, it is 0.
Command Mode
Global Configuration Mode
Example
Map CoS 5 to TC 2.:
T3700G-52TQ(config)#classofservice queue min-bandwith 5 2
24.7 show classofservice interface
Description
The show classofservice interface command is used to display the
configuration of Classofservice based on port priority.
Syntax
show classofservice interface [ fastEthernet port | gigabitEthernet port |
ten-gigabitEthernet
port | port-channel lagid ]
Parameter
port —— The Fast/Gigabit/ten-Gigabit Ethernet port number.
lagid ——The ID of the LAG.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the configuration of Classofservice for Gigabit Ethernet port 1/0/5:
T3700G-52TQ#show classofservice interface gigabitEthernet 1/0/5
24.8 show classofservice cos-map
Description
The show classofservice cos-map command is used to display the
configuration of IEEE802.1p Priority and the mapping relation between cos-id
and tc-id.
Syntax
show classofservice cos-map
180