JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
46.10 timers throttle spf
Description
The timers throttle spf command is used to configure the computing delay
and interval of the SPF, thus preventing the consumption of the CPU and
memory caused by frequent SPF computing. To restore to the default value,
please use the no timers throttle spf command.
Syntax
timers throttle spf
spf-delay spf-holdtime
no timers throttle spf
Parameter
spf-delay
—— The delay time of the SPF computing, ranging from 1 to 600
seconds. The default value is 5 seconds.
spf-holdtime
—— The minimum interval between two SPF computings,
ranging from 1 to 600 seconds. The default value is 10 seconds
Command Mode
Router Configuration Mode
Example
Configure the computing delay and interval of the SPF as 10 seconds:
T3700G-52TQ(config)# router ospf 1
T3700G-52TQ(config-router)# timers throttle spf 10 10
46.11 compatible rfc1583
Description
The compatible rfc 1583 command is used to configure the OSPF’s
compatibility for the routing rules in the RFC 1583. To cancel the
compatibility, please use the no compatible rfc1583 command. It is
compatible by default.
Syntax
compatible rfc1583
406
To Next Page
Loading...
