TP-Link JetStream T3700G-52TQ - Lldp Med-Tlv-Select; Show Lldp

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Example
Enable the LLDP-MED feature for port 1/0/2:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/2
T3700G-52TQ(config-if)# lldp med-status
36.9 lldp med-tlv-select
Description
The lldp med-tlv-select command is used to configure LLDP-MED TLVs to
be included in outgoing LLDPDU for the corresponding port. To exclude
LLDP-MED TLVs, please use no lldp med-tlv-select command. By default, All
TLVs are included in outgoing LLDPDU.
Syntax
lldp med-tlv-select { [inventory-management] [network-policy] [all] }
no lldp med-tlv-select { [inventory-management]
[network-policy] [all] }
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Exclude “network policy” and “inventory” TLVs in LLDPDU outgoing from port
1/0/2:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/2
T3700G-52TQ(config-if)# no lldp med-tlv-select network-policy inventory-
management
36.10 show lldp
Description
The show lldp command is used to display the global configuration of LLDP.
Syntax
show lldp
316