TP-Link JetStream T3700G-52TQ - Class; Assign-Queue

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
25.27 class
Description
The class command is used to add an existing DiffServ class to the policy. To
remove a class from the policy, please use no class command.
Syntax
class class-map-name
no class class-map-name
Parameter
class-map-name —— Specify the name of the class, ranging from 1 to 31
characters.
Command Mode
Policy-Map Configuration Mode
Example
Create a policy named tp and specify it to inbound traffic, then add a class
named market to the policy:
T3700G-52TQ(config)#policy-map tp in
T3700G-52TQ(config-pmap)#class market
25.28 assign-queue
Description
The assign-queue command is used to assign the matching packets to the
specific queue.
Syntax
assign-queue queue-id
Parameter
queue-id —— The ID of the assigned queue, ranging from 0 to 6.
Command Mode
Policy-Class-Map Configuration Mode
Example
Enter the Policy-Map Config mode for a policy named tp, then add a class
named market to the policy, assign the matching packets to queue 3:
198