JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
3.8 switch stack-port
Description
The switch stack-port command is used to enable the stack port. To switch
the stack port to Ethernet port, please use no switch stack-port command.
Port 1/0/25 and 1/0/26 are in Stack Port Group 1 and 1/0/27 and 1/0/28 are in
Stack Group 2. Stack feature can only be enabled in one group at a time.
Syntax
swtich stack-port interface ten-gigabitEthernet
port
no switch
stack-port interface ten-gigabitEthernet
port
Parameter
port
āā The ten-gigabit port number.
Command Mode
Global Configuration Mode
Example
Specify the ten-gigabit port 1/0/28 as a stack port:
T3700G-52TQ(config)# switch stack-port interface ten-gigabitEthernet
1/0/28
3.9 switch provision
Description
The switch provision command is used to configure the provisioned stack
member. The provision configuration feature enables you to configure a new
switch in advance before it joins the stack, which means you can configure
the stack unit number and its switch type which is not currently the stack
member.
The information of the provisioned member is manually created, or
created/updated by the switch member when it joins the stack. The
provisioned configuration retains in the stack when the stack member leaves
the stack.
26
To Next Page
Loading...
