JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
interface ten-gigabitEthernet / interface range ten-gigabitEthernet / interface
port-channel)
Example
Configure the loopback detection process-mode as port-based and
recovery-mode as manual for port 2:
T3200G-52TQ(config)# interface gigabitEthernet 1/0/2
T3700G-52TQ(config-if)# loopback-detection config process-mode
port-based recovery-mode manual
28.6 loopback-detection recover
Description
The loopback-detection recover command is used to remove the block
status of selected ports or LAGs, thus recovering the blocked ports to normal
status.
Syntax
loopback-detection recover
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet / interface
port-channel)
Example
Recover the blocked port 2 to normal status:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/2
T3700G-52TQ(config-if)# loopback-detection recover
28.7 show loopback-detection global
Description
The show loopback-detection global command is used to display the global
configuration of loopback detection function such as loopback detection
220
To Next Page
Loading...
