TP-Link JetStream T3700G-52TQ - Passive-Interface

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
no compatible rfc1583
Command Mode
Router Configuration Mode
Example
Configure the OSPF’s compatibility for the routing rules in RFC 1583:
T3700G-52TQ(config)# router ospf 1
T3700G-52TQ(config-router)# compatible rfc1583
46.12 passive-interface
Description
The passive-interface command is used to prevent an interface from
sending OSPF packets. To restore to the default settings, please use no
passive-interface command. The interface is allowed to send OSPF packets
by default.
Syntax
passive-interface { { fastEthernet | gigabitEthernet | ten-gigabitEthernet }
port | loopback id | vlan vlan-id }
no passive-interface { { fastEthernet | gigabitEthernet |
ten-gigabitEthernet }
port | loopback id | vlan vlan-id }
Parameter
fastEthernet | gigabitEthernet | ten-gigabitEthernet —— The port type of the
interface.
port —— The port number.
id —— The interface loopback ID.
vlan-id —— The interface VLAN ID.
Command Mode
Router Configuration Mode
Example
Prevent interface VLAN 1 from sending OSPF packets in routing process 1:
T3700G-52TQ(config)# router ospf 1
407