TP-Link JetStream T3700G-52TQ - Class-Map Match-All; Class-Map Rename

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
class-map-name —— The name of an existing DiffServ class, ranging from 1
to 31 characters.
Command Mode
Global Configuration Mode
Example
Enter the Class-Map Config mode for class tp:
T3700G-52TQ(config)#class-map tp
25.3 class-map match-all
Description
The class-map match-all command is used to create a class. Only the packet
that meets all the criteria included in the class can be considered as the
member of the class. To delete a class, please use no class-map command.
Syntax
class-map match-all class-map-name [
ipv4 | ipv6
]
no class-map class-map-name
Parameter
class-map-name —— Specify the name of the class, ranging from 1 to 31
characters.
ipv4 | ipv6
—— Specify the type of the class. By default, it is ipv4. Choosing
“ipv4” means only ipv4 packets can match the corresponding class.
Command Mode
Global Configuration Mode
Example
Create a class whose name is “tp”:
T3700G-52TQ(config)#class-map match-all tp
25.4 class-map rename
Description
The class-map rename command is used to rename a class.
184