TP-Link JetStream T3700G-52TQ - Show Logging Buffer; Show Logging Flash

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
18.14 show logging buffer
Description
The show logging buffer command is used to display the log information in
the log buffer according to the severity level.
Syntax
show logging buffer [ level level ]
Parameter
level —— Severity level. There are 8 severity levels marked with values 0-7.
The information of levels with priority not lower than the select level will
display. Display all the log information in the log buffer by default.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the log information from level 0 to level 5 in the log buffer:
T3700G-52TQ(config)#show logging buffer level 5
18.15 show logging flash
Description
The show logging flash command is used to display the log information in
the log file according to the severity level.
Syntax
show logging flash [ level level ]
Parameter
level —— Severity level. There are 8 severity levels marked with values 0-7.
The information of levels with priority not lower than the select level will
display. Display all the log information in the log file by default.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
113